Anyone who camps or has kids who build backyard forts has good use for a big tarp. This inexpensive, easytobuild version has a myriad of uses; its finished size is roughly 10 feet square.



Cut the material into two 3 1/2yard sections. In a wellventilated room, singe and seal all cut edges of both pieces of material. Light a candle. Hold the fabric with one cut edge stretched between your hands, and carefully pass the stretched edge of the fabric near the candle flame so that the fibers at the cut edge melt and fuse together. This prevents the finished tarp from raveling. Sear the cut edges of both pieces of material, working slowly cheap uggs and carefully around the panels. Blow the candle out.



Place one piece of material directly over the other, coated sides together. Pin together along the seam line. Sew the two pieces of material together lengthwise along one 3 1/2yard edge, using a sewing machine set to make close stitches; leave a 1inch seam allowance. Remove the pins along the seam. Open the sewntogether panels to form one large sheet with a seam down the middle, seam side up.



Holding the two seam allowances together, fold them under lengthwise and then fold them again in the same direction to produce genuine ugg boots a flatfelled seam of five thicknesses. Pin the seam and stitch it in two parallel rows down the tarp, once close to the fold and again close to the original seam. This flatfelled seam is the inside of the tarp. Remove the pins along the seam.



Turn the edges of the tarp under 1 inch and then under again 1 inch to make a 1inch hem on the inside; pin the hem in place and then stitch it all around close to the foldedunder edge. Backstitch at the beginning and end and tie off the thread ends. Remove the pins. For added strength, topstitch close to the edge around the entire tarp. This is all the sewing you'll have to do.



To complete the tarp, set grommets around its edges within the 1inch hem. Mark grommet points with chalk in each corner, midway on both of the long sides (parallel to the center seam), and just next to the points where the center seam hits the shorter sides; if desired, place more grommets along the sides of the tarp. Reinforce each marked grommet point with a piece of cloth adhesive tape. On the inside, set a grommet at each reinforced point with a grommet setter.



Finally, apply seam sealer for nylon along the open joints of the center seam, sealing the entire length of both the inner and outer surfaces. Let the sealer dry completely, as directed by the manufacturer, before using the tarp.



If you're a camper who loves to hike, you may own a wornout pair of hiking boots that are headed for the trash. Before you ditch them, consider breathing new life into them by replacing the soles. The next page will tell you how.